PEEL AND STICK TILE DECALS

INSTALLATION INSTRUCTIONS

 

Surface Preparation 

Floors must be clean, dry and dust free. Sweep and vacuum flooring before mopping with a mild cleaning solution. Allow to dry completely.

Backsplashes must be clean, dry and dust free. Wipe down the entire surface using a damp cloth and mild soap solution to remove any debris or dust. Allow to dry completely.

Avoid creasing or sharp folds as this may damage the print.

Tile Installation

1. Before getting started, carefully access your space to determine the best place to start. Start by peeling 2-3 inches of the backing away from the tile and placing it down. Continue to remove the backing slowly. Using your hand or a squeegee, smooth the tile onto the floor from the middle to the edges.

2. Move through your space from center to edges and continue until your project is complete.

  • Tip: If you are using our 12”x12” tiles you can opt to leave the grout lines or cover them.

3. When the tile meets the edge of your space, work the tile into the edge by using a straight edge to tighten it against your edge. Use a clean, sharp razor blade to trim any excess. 

Cleaning & Maintenance

Clean with a lightly dampened cloth or sponge with warm water. Pat gently with a clean soft cloth or bath towel to remove any surface moisture. Avoid aggressive rubbing.


Disclaimer

Handle tile decals with care and inspect upon receiving your order. Any problems that occur during the preparation or installation process are not the responsibility of Greenly Living.

 

A SANCTUARY OF STYLE AWAITS.